For Wi-Fi client devices connect to the ARRIS-XXXX (Service Set Identification) located on the bottom white sticker of the device.Wi-Fi enabled with encrypted or unencrypted wireless data activity.Ģ.4 GHz Wi-Fi connection is made between the SBG10 and another Wi-Fi enabled device on your home network for example Wi-Fi telephone, tablet, or laptop.ĥ GHz Wi-Fi connection is made between the SBG10 and another Wi-Fi enabled device on your home network for example Wi-Fi telephone, tablet, or laptop.

Wi-Fi cable modem is connected to the network. The Send/Receive and Online LEDs flash during the initial startup.

Check for solid 5 LEDs on the front panel of the SBG10 gateway.

There may be up to a 15 sec delay for the Power LED on the SBG10 front panel to light up after the power is connected.

NOTE: This automatically powers ON the SBG10.

Connect the power cord to the Power port on the rear of the SBG10 and then plug it into an electrical wall outlet that is not controlled by a wall switch.

NOTE: Client device with Ethernet connection is not required to complete installation.

Connect the Ethernet cable to the Ethernet port on the computer and to the Ethernet port on the rear of the SBG10.

Hand-tighten the connectors to avoid damaging them.

Connect the coaxial cable to a cable wall outlet (if not connected) and the Cable connector on the rear of the SBG10.

NOTE: Although older versions of Microsoft Windows operating systems are no longer specifically supported, they should still function with the SBG10.

Web browser access - Internet Explorer, Google Chrome, Firefox, or Safari.

Ethernet cable for each additional Ethernet-enabled device.

RF splitter (for additional coaxial cable connections, such as a set-top box or Smart TV).

Coaxial (coax) cable, if one is not already connected to a cable wall outlet.

This document describes the basic installation process for the SBG10 Gateway.īefore beginning the installation, check that the following items were included with the SBG10 Gateway:

Arris sbg10 cm mac number